What is the difference between C110 and C153?

What is the difference between C110 and C153?

Description: Today, standard compact fittings C153 are commonly used in place of full Body fittings C110. They are designed to be to be more lightweight and more economical to use while providing better flow characteristics.

What is a transition gasket?

The MJ X IPS Transition gasket is designed to be used in cast iron mechanical joint fittings for adapting to PVC or steel pipe (IPS dimensions). These gaskets made of SBR are usually used for water and domestic sewage service.

What is AWWA C110?

Back to AWWA C110-12 Ductile-Iron and Gray-Iron Fittings (PDF) This standard describes 3- to 48-in. (80- to 1,200-mm) gray-iron or ductile-iron fittings to be used with ductile-iron pipe for potable water, wastewater, and reclaimed water for a temperature range of 33º-120ºF (0.6º-49ºC).

What is AWWA C153?

Back to AWWA C153-11 Ductile-Iron Compact Fittings. This standard describes 3-in. through 64-in. (80-mm through 1,600-mm) ductile-iron compact fittings to be used with ductile-iron pipe or pipe made of other materials with similar outside diameters for conveying potable water, wastewater and reclaimed water.

What is AWWA C150?

Back to AWWA C150-08 Thickness Design of Ductile-Iron Pipe. This standard describes the thickness design of ductile-iron pipe complying with the requirements of ANSI/AWWA C151/A21. 51, Ductile-Iron Pipe, Centrifugally Cast, for Water.

What is a Megalug?

The Series 1100 MEGALUG® Mechanical Joint Restraints effectively and economically restrain Ductile Iron Pipe (DIP) to mechanical joints above or below ground, for practically any application including valves, hydrants, and pipe.

What screwed fittings?

The Screwed Elbow Fitting is a pipe fitting installed between two lengths of pipe or tube allowing a change of direction, usually 90° or 45°. The ends can be be machined for screwed (usually female), or socketed. When the two ends differ in size, it is called a Reducing or Reducer Elbow.

What is AWWA C800?

AWWA C800, 2014 Edition, June 8, 2014 – Underground Service Line Valves and Fittings. This standard covers valves, fittings, service saddles, and meter setters for use in a service line from the main through the meter valve or meter-setting appurtenance.

What is ductile iron pipe made of?

ductile cast iron
Ductile iron pipe, made from ductile cast iron, is a graphite-rich cast iron in which the graphite has a spheroidal shaped molecular structure. This molecular structure makes the cast iron less brittle and more resistant to impact than the other varieties, which have a flaky structure.

What is class K9 ductile pipe?

Stockholder DI pipe Class k9 in india. Class K9 DI pipe specification is based on the Nominal Wall Thickness as well as the Nominal Diameter of the pipe. DI K9 Pipes are heavier than Ductile Iron Class K7 pipes. Ductile Class K9 pipes are resistant to corrosion and there is no need for cathodic protection for them.

What is mechanical joint pipe?

Mechanical joint pipe is a time-tested ductile iron product with joint dimensions conforming to the standardized dimensions in AWWA C111. Mechanical joint pipe is UL Listed and FM Approved.