Trending 

How long does it take to remove rear axle?

Author

How long does it take to remove rear axle?

If the axle, flange gasket, wheel bearings, brakes, wheel seal, and gear oil was replaced, then the time is 3.75 hours, which is 3 hours and 45 minutes, unless there was an issue with the axle being stuck in the axle housing or the s-cams needed new bushings.

How do you remove an axle?

If the car does not have this bearing use a large pry bar and wedge it between the transmission case and the axle and pry outward. This will pop the axle out from the transmission and enable you to remove the axle. Grasp the axle firmly while holding the spindle outward and pull the axle out from the transmission.

What size is the axle nut on a 2004 Ford Explorer?

The 2004 Ford Explorer is fitted with a rear axle nut that measureS36mm hex. To access it, You’ll first need to remove Your tire, which has a universal bolt pattern of 5 X114. 3. This means that each wheel is secured with 5 lug nuts, each of which have thread measuring 1/2″ – 20 UNF.

What size is the axle nut on a 2006 Ford Explorer?

The rear axle nut size for a 2006 Ford Explorer is 22 mm. The axle nut is what holds the hub to the axle. It is the hub on the disc behind the wheel that the wheel bolts onto. It is recommended that if You have to remove an axle nut, You should discard it and replace it with a brand-new one.

How do I identify a Ford 8.8 rear end?

You can identify the Ford 8.8-inch rear by its rear cover. It has a thin metal or plastic 10-bolt cover, and the bolts are 7/16-inch thread. The cover is not quite square, measuring about 101/2 inches high by 11 inches long. The 8.8-inch pinion shaft is 15/8 inches and has 30 splines.

How do you remove the rear axle on a Ford f150?

Step 1 – Remove the rear wheels

  1. Park on flat, level ground.
  2. Set the emergency brake and put the truck in neutral.
  3. Chock front wheels on both sides of the wheel.
  4. Using tire iron, loosen rear lug nuts.
  5. Raise vehicle with floor jack and position the jack stand under the rear axle.
  6. Remove lug nuts and the remove the wheel.