Why is the water cooler not dispensing water?

Why is the water cooler not dispensing water?

If no water is flowing from your bottled water cooler or dispenser, there are generally two main causes: either the reservoir has become frozen, or the air filter is water-saturated due to a leaky bottle or dirty. If your water cooler was frozen you should probably adjust the temperature of the thermostat.

Why is my oasis water dispenser not working?

According to Oasis technical support, the most common cause of water cooler problems is a dirty condenser. Oasis recommends taking a look at the condenser and making sure it is clean. A dirty or clogged condenser can affect the thermostat, resulting in water that is either to warm, too cold or frozen.

Why does my water cooler keep freezing?

If your water cooler keeps freezing there are problems with the system. Either the temperature is set too low or you have a problem with the Freon going into the water. Resetting the temperature is a fairly straightforward process.

How do I make my water colder?

Put your water bottle in the fridge for several minutes until the water cools down. Depending on how cold your refrigerator gets, it might take a while to get your water cold. Putting your bottle in the freezer will cool it down faster.

How do I increase the pressure in my drinking fountain?

Locate the push button on the front of the drinking fountain 2. This contains a regulator screw. Place a small screwdriver in the hole of the button and turn the screw clockwise to increase the pressure and raise the stream height.

How do I clean the condenser on my Oasis Water Cooler?

To remove dirt and lint from the condenser, disconnect the power supply cord from the electrical outlet, and then clean the condenser with a small stiff non-wire brush or vacuum cleaner attachment brush. Oasis recommends inspecting the condenser every 3 months. Why is the water cooler still not cooling (condenser is clean and functioning)?

How do you clean the inside of a water cooler?

Remove the lid and baffle (the baffle will be either a white or blue plastic funnel or disk, depending on the manufacturer) from the reservoir. Add 1 cup of vinegar to about 2 litres of hot water and use a soft, clean cloth to wipe the inside of the reservoir. Then drain all excess water from the cooler’s taps.

What add-on bottle fillers are available for Oasis Water Coolers?

There are two add-on bottle filler options: a manually activated retrofit bottle filler (Oasis model PWSBF) and a sensor activated retrofit bottle filler (Oasis model PWEBF) Which water coolers can be retrofit with an Oasis bottle filler?

Where do I find the model number on my Oasis Water Cooler?

Oasis model numbers are found on the bottom of the drinking fountain, water cooler, or bottle filler. The model number can be found most often on a sticker located on the bottom of the frame on the outside. Is there an antimicrobial option for water cooler finishes? Yes, some Versacooler units are available with antimicrobial parts.