What screwdriver is needed to open 3DS?

What screwdriver is needed to open 3DS?

Important: A #00 cross-head (+) screwdriver will be required to change the battery pack on the Nintendo 3DS, Nintendo 3DS XL, and Nintendo 2DS.

How do you remove a screw from a 3DS without a screwdriver?

If you do not have a flat head screwdriver then you can usually use any kind of flat surface to unscrew the screw. Use a card. Try using a card such as a plastic credit card to turn the screw. Insert the edge of the card into the long groove and turn counterclockwise to unscrew the screw.

What size are the screws on a Nintendo 3DS?

Use a size #0 cross-head (+) screwdriver to loosen the screws from the back cover plate.

Does a 3DS need a battery?

This battery is a replacement for the one included in every New Nintendo 3DS™ XL or Nintendo 3DS™ XL. If your system is not charging or holding a charge properly, we recommend checking our troubleshooting before deciding on a replacement. A maximum of 2 lithium ion batteries per order.

How do you take apart a DS?

If you are taking apart your DS, watch for ribbon cables. Ribbon cables are the brown-colored cables you find in most DS’s. To unplug them, gently lift up the cable from the connector. Make sure you’re not too rough on them, or else they’ll break, resulting in a technically useless Nintendo DS. Thanks!

How do I change the back cover plate on the New 3DS?

A #0 cross-head (+) screwdriver (not included) will be required to change the back cover plate on the New Nintendo 3DS. Do not over tighten the screws. This may result in stripping them or cracking the housing. Always make sure the cover plates are securely attached to the New Nintendo 3DS system before using it.

How do you change the battery in a Nintendo DS?

1 Remove a two rubber tabs on the back side of Nintendo DS, and open the battery cover using the Quatro-wing screwdriver. 2 Remove all those screws using the Quatro-wing screwdriver and Tri-wing screwdriver. 3 Remove a battery and unscrew a two screws, which are beneath the battery.

How do you fix a broken T-screen on a DS?

You might have to flip it upside down and poke it with the screwdriver to make the t-screen work again. If you are taking apart your DS, watch for ribbon cables. Ribbon cables are the brown-colored cables you find in most DS’s. To unplug them, gently lift up the cable from the connector.