What tools do I need to replace a wheel hub assembly?

What tools do I need to replace a wheel hub assembly?

What tools do you need to install a wheel hub assembly?

  1. Safety glasses.
  2. Wheel chocks.
  3. Jack and jack stands.
  4. Ratchet, various size sockets and various size wrenches.
  5. Breaker bar.
  6. Mallet.
  7. Punch.
  8. Torque wrench.

Can you replace a wheel hub without replacing the bearing?

Your wheel bearing may have been damaged slightly in the past and has now worn to the point it is starting to make noise. Your mechanic is correct in that the only repair for the bearing is to replace the hub. It is a sealed unit and cannot be disassembled without destroying it.

Can you replace a wheel hub yourself?

Changing your own wheel bearings is considered an intermediate job that can be done at home, but will need some speciality mechanic tools. Be sure to obtain your vehicle’s service manual and identify the type of wheel bearing your vehicle is equipped with before you begin the repair.

How long does it take to replace a wheel hub assembly?

How long does it take to replace Wheel Bearings? Replacing a single wheel bearing can take 90 to 120 minutes depending on the type of vehicle and complexity. There are a lot of moving parts that need to be maintained and properly sealed to complete this type of work.

How long does it take to replace a wheel bearing hub assembly?

Experience is one of the key factors affecting installation time. For new technicians, turnaround time can be up to two hours. However, that time can be cut in half by experienced technicians, especially if there are no delays in acquiring parts or tools.

Should you replace wheel hubs in pairs?

You should replace your hub assembly and wheel bearings. Here’s how to replace wheel bearings. Even if only one side is bad, it makes sense to replace them in pairs. The “good” side is likely to cause problems in a relatively short time.

How much does it cost to replace hub assembly?

You will pay from $130 to $550 for hub assembly replacement. The labor should cost you about $70-$90, while parts will run between $65 to $400.

How do you replace a wheel hub assembly on a car?

Step 1: Prepare your work area. Step 2: Loosen the lug nuts. Step 3: Jack the vehicle up and use jack stands. Step 4: Remove the old wheel hub assembly. Step 5: Install the new wheel hub assembly and brake parts. Step 6: Reinstall the wheels. Step 7: Jack the vehicle back off of the jack stands. Step 8: Torque the wheels.

What is a wheel bearing and hub assembly?

Today’s modern cars, and those manufactured after 1997 are equipped with a single bearing and hub assembly that is attached to each wheel and tire on a vehicle.

What happens when a wheel hub assembly goes bad?

Typically when a wheel hub assembly goes bad it’s actually the wheel bearing inside the single assembly that is damaged. This part will make a roaring sound, similar to a metal-to-metal grinding sound when the bearing is wearing out.

How do you replace a brake rotor on a car?

Work in the reverse order of the way you removed everything. Start by bolting the new wheel hub assembly to the knuckle and connecting the ABS sensor connector if there was one. Next, torque the bolts to specs, which can be found online or in the vehicle’s service manual. Install the rotor back onto the hub and start reassembling the brakes.