How do I fix the SRS light on my Honda Accord?

How do I fix the SRS light on my Honda Accord?

How to Reset a Honda Accord SRS Light

  1. Straighten out a paperclip.
  2. Pull down on the fuse panel cover under the steering column with your fingers to remove it.
  3. Locate the small yellow plug in the fuse panel.
  4. Unplug the power connector from the fuse panel.

How do I fix my SRS airbag warning light?

How to Reset an Airbag Light

  1. Put the key into the ignition and turn the switch to the “on” position.
  2. Watch for the airbag light to turn on. It will stay illuminated for seven seconds and then shut itself off. After it shuts off, immediately turn the switch off and wait three seconds.
  3. Repeat Steps 1 and 2 two more times.

Can I drive my car with the SRS light on?

So is it safe to drive with an SRS light on? The answer would be no, Even though there’s a possibility that the airbags could still deploy with the light on it is a huge risk if one were ever involved in an accident. We recommend having a professional look at it and diagnose the issue to have fixed immediately.

Why is my airbag light on in my 2005 Honda Accord?

NHTSA reports that Honda is recalling 81,000 2004 – 05 Accord sedans because of an airbag sensor that was installed improperly. If owners see the airbag light go off, they should have their car serviced immediately. Under the recall, all owners will have the sensor wiring harness replaced.

How much does it cost to fix SRS light?

What is typical cost to resolve an illuminated Supplemental Restraint System (SRS) Warning Light? Expect to pay between $100 to $200 for the initial diagnostic.

What would cause the SRS light to come on?

The most common cause for the airbag light coming on is that the airbag system is deactivated or turned off. There may be an issue with a crash sensor, SRS module, or other airbag component. Alternatively, the sensor in the passenger seat that determines whether that airbag should be active or not may be faulty.

What causes SRS light to stay on?

The airbag warning light should only stay on when there’s a problem with the airbag system in the car. If the airbag hasn’t been deployed, the light will come on when the system senses that it cannot activate the airbag; this means that there is some sort of a problem with the airbag system in your vehicle.

What is SRS code for Honda?

If your Honda airbag light remains on, it most likely means that the Supplemental Restraint System (SRS) has detected a problem with the airbag system. When your Honda airbag system functions properly, the airbag light comes on when you turn on the ignition but should turn off once you start the engine.

What is a SRS light?

If the SRS light illuminates while you are driving, it signals there’s an issue with the car’s airbag system. It also means that the airbags may not deploy if you’re in an accident. If the light comes on, take your car to get the SRS sensor checked as soon as possible.

What are SRS codes?

The SRS warning light refers to the Supplemental Restraint System (SRS) and is most commonly known as the airbag system light. This is a computer controlled system designed to deploy one or more driver, passenger, and side airbags.

What causes SRS light?

If the SRS light stays on or starts flashing on and off, you may have a problem with the airbags themselves, a loose wire, a faulty seat belt buckle, or a problem with the Engine Control Unit (ECU) that is causing the airbag warning light to stay on.

What does the SRS light mean on a 2002 Honda Accord?

SOLVED: SRS light is on – 1998-2002 Honda Accord – iFixit I actually dealt with this last week at my shop. The SRS light is a warning light for your supplemental restraint system (airbags). An SRS light means that there is a problem in the system.

What does the airbag light mean on a Honda Accord?

If your Honda airbag light remains on, it most likely means that the Supplemental Restraint System (SRS) has detected a problem with the airbag system.

How to reset the SRS light on a Honda Honda?

Honda: How to Reset the SRS Light 1 Locate the MES. Locate the MES (Memory Erase Signal) connector. 2 Short the MES. In this step, you will internally make the connection in the plug to “short” it. 3 Cycle the ignition. With this connection made, turn the ignition key to the “on” position (do not start the engine).

What does the SRS light mean on a Toyota Corolla?

The SRS light may indicate a problem with a sensor in the steering wheel, seat, or onboard computer. But even if you discover the reason for the problem, the light does not reset itself.