How do I fill my Allison transmission fluid?

How do I fill my Allison transmission fluid?

Registered

  1. remove tranny drain plug (should tranny be at any specific temp for good drain?)
  2. remove spin on filter making sure to collect magnet.
  3. fill new filter with some fresh ATF.
  4. replace drain plug (any type of thread sealant necessary?
  5. fill tranny through dip stick tube.

How do you check Allison transmission fluid level?

operating temperatures.

  1. Pull out the dipstick and wipe it with a clean rag or.
  2. Push it back in all the way, wait three seconds and.
  3. Check the fluid level reading.
  4. If the fluid level is within the COLD CHECK band, the.
  5. Perform a hot check at the first opportunity after the.

How many quarts does an Allison 3000 take?

29 quarts
Allison 3000 transmissions can hold approximately 29 quarts of fluid; the larger Allison 4000 can hold approximately 48 quarts. But not all of this fluid is in the transmission pan.

What fluid goes in an Allison transmission?

Mobil Delvac 1 ATF is a fully synthetic fluid recommended by Allison Transmission, Inc. and approved against the Allison TES-295 and TES-468 Specifications. The fluid is designed to meet the demanding requirements of modern heavy-duty automatic transmissions.

Where do you put transmission fluid in a Duramax?

Slide the long neck funnel into the dipstick holding tube. Pour Dextron VI automatic transmission fluid into the funnel until the fluid level is near or at the full mark on the dipstick. A completely empty transmission on a Duramax diesel engine will hold around 13 quarts of fluid.

What type of fluid does an Allison Transmission take?

Advanced technology synthetic automatic transmission fluid Mobil Delvac 1 ATF is a fully synthetic fluid recommended by Allison Transmission, Inc. and approved against the Allison TES-295 and TES-468 Specifications. The fluid is designed to meet the demanding requirements of modern heavy-duty automatic transmissions.

What kind of transmission fluid do you put in a Allison Transmission?

Allison Transmission TES 295® Approved Fluids are approved for use in Allison 1000 Series™, 2000 Series™, 3000 Series™, 4000 Series™ and H 40/50 EP™ on-highway products. Allison recommends that customers using TES 295® Approved Fluid consider Allison’s newest fluid spec, TES 668™, for their next service.

What fluid does a Allison Transmission take?

How many gallons of transmission fluid does a Allison Transmission take?

2 Gallons
2 Gallons of Allison Transynd synthetic fluid- (We have found this fluid to be far superior to anything else available.) It is completely compatible with Dexron 3 and Dexron 6 designed specifically for the Allison transmission. 1 genuine Allison spin on transmission filter.

What type of transmission fluid does Allison use?

Allison recommends that customers use an Allison Approved TES 295® automatic transmission fluid to extend drain intervals and enhance transmission performance and durability in all operating environments with on-highway products.

How many quarts of fluid to use on an Allison?

Allison gives 10.6 quarts for a refill. But if you installed the deep pan, you changed the internal sump/filer to the one for the deep pan (I hope) When you pull the internal filter out, more fluid drains. But 12 quarts seems a bit much – if you are certain of your amounts and depending on where you were on the dip stick to begin with.

What kind of oil for Allison Transmission?

Mobil Delvac 1 ATF is a fully synthetic fluid recommended by Allison Transmission, Inc. and approved against the Allison TES-295 and TES-468 Specifications. The fluid is designed to meet the demanding requirements of modern heavy-duty automatic transmissions.